Akademik Veri Yönetim Sistemi
Measurement: Journal of the International Measurement Confederation, cilt.235, 2024 (SCI-Expanded)
In this research, the effects of laser power, laser welding speed and laser incidence angle were evaluated in terms of weld geometry, microstructure, microhardness, fracture surfaces and tensile shear load in fiber laser welding joints of DP1200 steel sheets. Response Surface Methodology (RSM) was utilized to derive mathematical relationships between the process parameters and the tensile shear load after the tensile test. The optimum combination of process parameters was a laser power of 2800 W, a laser welding speed of 40 mm/s, and a laser incidence angle of 70°. A thermal camera was used to record the laser welding process, and the cooling rates were evaluated by analyzing this data. The influence of cooling rate upon microstructure phase formation for DP1200 steel is investigated, with continuous cooling transformation (CCT) diagrams. Also, post-welding stress and displacement were simulated by Simufact Welding software. At high heat input (55.79 J/mm) occurred coarse dendritic martensitic lath growth while at low heat input (37.6 J/mm) fine dendritic martensitic structure was observed in the weld zone was obtained owing to the high rate of cooling. The microstructure consists of full martensite at a higher than 10 °C/s cooling rate. The findings reveal that the phases in FZ and HAZ, the morphology and martensite/bainite constituents differed related to the heat input and laser incidence angle, which ultimately affects the joint's microhardness, fracture dynamics and tensile shear load.